10-21-2010 04:46 PM - edited 07-03-2021 07:19 PM
Hello,
We are working with WLC 5508 version 7.0.98.0 and we want to secure (encrypt) mobility messages between controllers but the command "config mobility secure-mode enable" apparently doesn't exist in this WLC version.
Does anybody know how to configure secure mode for mobility messages (udp port 16667) on this WLC version?
Thanks in advance.
Regards,
Mario
Solved! Go to Solution.
10-24-2010 11:27 PM
Hi,
Here is the bug ID..CSCtd14357
Regards
Surendra
10-24-2010 11:20 PM
Hi Mario,
This is not possible anymore. If you check the 7.0 config guide there is no mention of secure mode anymore.
In the 5.1-5.2-6.0 config guides, they added a note to say that the secure mode was not supported even if command was present in command line.
So this is not configurable since some versions already.
I heard something is coming to replace this need but no idea what it will be yet.
Regards,
Nicolas
===
Please rate posts that you find useful
10-24-2010 11:27 PM
Hi,
Here is the bug ID..CSCtd14357
Regards
Surendra
10-25-2010 05:55 AM
Hello,
Thanks for the answers. We supposed that this feature was deprecated but we doubt since we found references to this mode in the 7.0 configuration guide and command reference guide.
Regards,
Mario
10-25-2010 06:50 AM
Can you mention where in the config guide ? This needs to be tackled and removed actually.
10-25-2010 07:24 PM
We found the following references:
1) WLC Configuration guide 7.0: page 809 (Chapter 14-5)
"All mobility message exchanges between controllers are carried out using UDP packets on port 16666. IPsec encryption can also be configured for
the inter-controller mobility messages, in which case port 16667 is used."
2) WLC Command Reference 7.0: page 663 (Chapter 2-649)
"config mobility secure-mode"
Regards,
Mario
10-25-2010 07:27 PM
Thanks for the update!! We will take care of this issue and we will make sure that this wont happen in future!!
Regards
Surendra
10-25-2010 10:25 PM
Great!!
i have checked the documantation and found that the there is some issues with the doc.. coz.. based on the Bug which i have provided.. you no longer see the command in 6.0 WLC configuration guide.. however we are able to see this on 7.0.. we will take care of this. and thanks for noticing this and helping us to improve..
Regards
Surendra
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide