08-09-2012 09:26 AM - edited 07-03-2021 10:30 PM
Hi guys,
I am trying to apply WLAN template from NCS to two WLCs 5508 and I receive this message.
"Another WLAN with same SSID and either WPA1/ WPA2/ WPA1+WPA2 is enabled. Please change the Layer 2 security policy."
The template has layer 2 security with WPA+WPA2 enable and 802.1x.
I have other WLAN template with other name and other SSID with the same security policies with no problem to apply.
Did somebody know this error?
Tks
Gilberto
08-09-2012 11:21 AM
Make sure ssid name in the template is not already exist on the WLC or the WCS.
Remove any duplicates and try again. If you try to change config on a wlan
hat is already exist but not able to then try disabling the wlan before making any changes.
HTH
Amjad
Sent from Cisco Technical Support iPad App
08-09-2012 01:45 PM
The problem is ok now.
NCS was keeping information about older wlan with the same name that doesn´t exist on controller.
I did audit controller to solve this issue.
Tks
Gilberto
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide