12-17-2015 04:20 AM - edited 07-05-2021 04:23 AM
Hii
i am try to convert AIR-AP1041N-E-K9 autonomous to Lightweight (Controller Base). i was successfully upgraded but it can not find the WLC IP.
I don't know why it happen. i have also check the switch and found it is fine and DHCP is enable.
i have also create a DHCP pool in my WLC.
But still it can find any IP address via WLC.
It shows the following error:
*Dec 17 11:27:49.827: %CAPWAP-3-DHCP_RENEW: Could not discover WLC. Either IP address is not assigned or assigned IP is wrong. Renewing DHCP IP.
Please check the attachments.
Regard
Yasib
Solved! Go to Solution.
02-12-2016 01:45 AM
Hi Sandeep,
Is there a way for us to know what channels the RRM is currently useing when the controller supports multiple countries? I am reading that RRM would use common channels which are allowed in all the countries the WLC support. But, when it comes to reality, how can we know what channels that RRM is using to assign to AP's?
01-18-2016 11:33 PM
AIR-CAP1702I-C-K9 | 802.11ac CAP; 3x3:2SS; Int Ant; C Reg Domain |
Im using the mentioned above AP and im facing the same problem,
I have configured the AP for IN (India) and Also Cofnigured for US(USA)
but AP doesnt join the WLC.
What country should i configure to solve the issue ?
Its urgent.
01-18-2016 11:55 PM
Hi Ariq,
Please create anew thread and please paste output of these commands:
sh sysinfo from WLC
sh version from AP.
Regards
Don't forget to rate helpful posts
01-19-2016 10:23 PM
HI Sandeep
Thanks for the posts,it was really helpful.
My problem is solved. AP joined the WLC, it was regulatory domain miss-match issue. I have changed the WLC's country to China and now its working fine.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: