Not able to Print Using IPAD 2 with CISCO Leight Weight ACCES Point

[ranjit123]

Dear All,

We have recently connected a IPAD 2 in our wireless N/W, it works perfectly fine.

But when we are tyring to use its AIRPRINT function its just not detecting the HP PRINTER.

But when we connect the HP printer to a DLINK device then the IPAD is able to detect the printer and AIRPRINT is happening.

Is ther any setting on the AP or WLC ( 4400) to detect the Printer

Kindly Check

Regards,

Ranjit

[phoenix7799]

Dear Ranjit,

Is the HP and Ipad on the same subnet? Could you specify the ip of those?

[ranjit123]

Dear Marco,

Both are on the same subnet

IP of IPAD ;--> 10.0.19.49/24

IP of Printer ;---> 10.0.19.69 /24

the IPAD is not able to detect the printer in wireless setting

[phoenix7799]

Could you please verify the Cisco WLC configuration? Let me know in private if you want mp@marcoprovenza.com

[ranjit123]

Dear All,

Same is working now.

Regards,

Ranjit

[phoenix7799]

good work!!!

[Justin Kurynny]

ranjit23,

What was the fix?

Justin

... typd on tny kybrd.

[blakekrone · Accepted solution]

Probably broadcast forward enabled and multicast setup, AirPrint uses the bonjour protocols as well.

Sent from Cisco Technical Support iPad App

[ranjit123]

Dear Blakekrone ,

You are absolutely right; we just enabled Multicast on the cisco AP and it started working.

Regards,

Ranjit