cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1355
Views
0
Helpful
8
Replies
Highlighted
Beginner

Not able to Print Using IPAD 2 with CISCO Leight Weight ACCES Point

Dear All,

We have recently connected a IPAD 2 in our wireless N/W, it works perfectly fine.

But when we are tyring to use its AIRPRINT function its just not detecting the HP PRINTER.

But when we connect the HP printer to a DLINK device then the IPAD is able to detect the printer and AIRPRINT is happening.

Is ther any setting on the AP or WLC ( 4400) to detect the Printer

Kindly Check

Regards,

Ranjit

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

Probably broadcast forward enabled and multicast setup, AirPrint uses the bonjour protocols as well.

Sent from Cisco Technical Support iPad App

View solution in original post

8 REPLIES 8
Highlighted
Beginner

Dear Ranjit,

Is the HP and Ipad on the same subnet? Could you specify the ip of those?

Highlighted

Dear Marco,

Both are on the same subnet

IP of IPAD ;--> 10.0.19.49/24

IP of Printer ;---> 10.0.19.69 /24

the IPAD is not able to detect the printer in wireless setting

Highlighted

Could you please verify the Cisco WLC configuration? Let me know in private if you want mp@marcoprovenza.com

Highlighted

Dear All,

Same is working now.

Regards,

Ranjit

Highlighted

good work!!!

Highlighted

ranjit23,

What was the fix?

Justin

... typd on tny kybrd.

Highlighted

Probably broadcast forward enabled and multicast setup, AirPrint uses the bonjour protocols as well.

Sent from Cisco Technical Support iPad App

View solution in original post

Highlighted

Dear Blakekrone ,

You are absolutely right; we just enabled Multicast on the cisco AP and it started working.

Regards,

Ranjit