cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1024
Views
0
Helpful
4
Replies

Option 43 WLC

kuldeep.kaur
Level 1
Level 1

Hi Guys,

 

If I have different models of access points says 1000 and 2000 series and if I want to use option 43, do i need to define them separately (I gone through the dhcp doc from cisco and looks like yes i have to as they have different values). Could someone please confirm ?

 

Thanks 

4 Replies 4

George Stefanick
VIP Alumni
VIP Alumni

So I have in all my deployments. Works fine without issue. However I think if u leave vci60 blank I think Steve said it would accept any model. But I never tested that .. 

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

Leo Laohoo
Hall of Fame
Hall of Fame

gohussai
Level 4
Level 4

 

Check the below document for clear understanding and proper configuration.

http://www.cisco.com/image/gif/paws/97066/dhcp-option-43.pdf

 

Note: You need to know before configuration the option 60 (VCI) , option 43 and sub-option TLV block .

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: