Problem with AP 1700I i cant access it through console,ssh, telnet

[migvzla3011]

Hello i am from Venezuela

I have AIR-CAP1702I-A-K9, but i cant access it through console,ssh, telnet, i know that there are two firmware:

1) Autonamos

2) Lightweight 

I bealive that my AP 1700 comes with Lightweigth, but a i dont have any controller, so i want access to the AP and become it to  autonumus, so my questions are:

1) The AP 1700I work stand alone

2) How can i access it without cisco controller?

best regars

[Saurav Lodh]

https://supportforums.cisco.com/video/11928901/lwapp-lightweight-mode-autonomous-conversion-and-vice-versa

[Moin Ilyas]

https://supportforums.cisco.com/document/57476/lwapp-autonomous-conversion-and-vice-versa-access-points

https://supportforums.cisco.com/document/71501/installing-autonomous-ios-aios-lightweight-ap-cli

[mohanak]

1) The AP 1700I work stand alone?

The 1700 series access point is available in both controller-based (Unified) and standalone (Autonomous) configurations, and supports:

• Simultaneous dual-band (2.4-GHz and 5-GHz) radios
• Integrated antennas (AIR-CAP1702I-x-K9)

2) How can i access it without cisco controller?

You need to have an account on Cisco.com to access Cisco Tech Zone. If you do not have an account, you can create one by clicking Register Now on the Log In page.

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/15-3-3/configuration/guide/cg15-3-3/cg15-3-3-chap4-first.html

[Leo Laohoo]

Hold on, hold on ... This is a 1700 right?

Console into the AP (username/password:  "cisco") and in enable mode, enter this command:  config capwap ap autonomous