cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1830
Views
0
Helpful
2
Replies

Problem WLC with apfMsConnTask_4

jmanzur1683
Level 1
Level 1

I have a Cisco WLC 5508, and it crashed, and this is the message of the crash:

"Analysis of Failure:

  Software was stopped by the reaper for the following reason:

     Reaper Reset: Task "apfMsConnTask_4" taking too much cpu: 100%  (user 18%, system 81%) while SW Watchdog is disabled"

Do you know what means this message?

Versio IOS:

7.0.98.0

2 Replies 2

George Stefanick
VIP Alumni
VIP Alumni

Hi Jorge,

I am not fimilar with that specific error message. But I do know, if you call TAC and tell them you are on 7.0.98.0 they will tell you to move to 7.0.220.0.

7.0.98.0 is a bit buggy.

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

Stephen Rodriguez
Cisco Employee
Cisco Employee

Basically, it is telling you that the Reaper task had to kill a process becuase it was taking up too much of the resources.  And it caused the box to crash.

But as George said, you'll want to upgrade to 7.0.220.0, as 98 is buggy.

HTH,

Steve

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: