cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
165
Views
0
Helpful
1
Replies
Highlighted
Rising star

Problems with LWAPs and Symbol Spectrum24 Client Bridge

Hello,

I am running a WLC 2006 with a couple of test LWAPs. I have everything running fine except for a Spectrum24 Client Bridge from Symbol. It is using an LA4121 card also from Symbol. Before you guys here flame me it cannot apparently use a Cisco card (or at least that is what the guy that controls this device is telling me). It has to have a static IP on it. I can get it to associate with the LWAP but the IP address shows up as 0.0.0.0 on the controller and it can't pass traffic. When I put the same card in a laptop and give it a static IP I am blazing away with no problems. Has anyone seen this before?

Thanks in advance. All replies will be rated

1 REPLY
Rising star

Re: Problems with LWAPs and Symbol Spectrum24 Client Bridge

Update: It appears that Work Group Bridges are not supported on the current version of code. A realease due out in May will take care of this issue.

CreatePlease to create content
Ask the Expert- MPLS troubleshooting