I am troubleshooting a problem where AP's are failing over from the primary wlc to the secondary. It isnt a shortage of bandwidth on our MPLS cloud.
Would like to see about enabling syslog on the ap's in an individual office (I have dhcp running on the local site router at each office where I have lwap enabled AP's located. If I need to enable it from the controller, I am open to that but wanted see about minimizing the syslog traffic as I would prefer to only watch syslog traffic from a couple of offices that I am watching.
When I have a hard console connection into a LWAP while it is booting up, I have seen an error about not syslog or logging info provided by dhcp. That is what got me thinking about going in this direction.
QuestionI have the following Air AP:Air-AP1562I-B-K9, 802.11ac outdoor access point There are three antenna cables that go from the inside cover to some soldered connections on a PCB. When removing the cover, two of the soldered antenna connections c...
QuestionHiWe have a guest access set up and was wondering what exactly are the sequence of events from connecting to SSID to being granted internet access, see below steps I'm unsure of are left blank1. connect o SSID through AP2. traffic hits Foreign WLC...
Model:C9120AXI-Q Install EWC on C9120 running with CAPWAP as shown in the attached log, but the installation fails.It looks like you're getting an error like out of storage space.Is there any good way?