We have installed 60 cisco access points in a site. all are working fine, except 10 access points. all the user are connecting to 2.4 Ghz radio and no users are connecting with 5.0 Ghz in those 10 access points only. Same users are able to connect with 5 Ghz radio in all other 50 access points.
1. all 60 access points are connected with same controller.
2. all access points are up and running with same firmware.
It would be great, if some one helped me to resolve this issue?,Thank you.
QuestionI have the following Air AP:Air-AP1562I-B-K9, 802.11ac outdoor access point There are three antenna cables that go from the inside cover to some soldered connections on a PCB. When removing the cover, two of the soldered antenna connections c...
QuestionHiWe have a guest access set up and was wondering what exactly are the sequence of events from connecting to SSID to being granted internet access, see below steps I'm unsure of are left blank1. connect o SSID through AP2. traffic hits Foreign WLC...
Model:C9120AXI-Q Install EWC on C9120 running with CAPWAP as shown in the attached log, but the installation fails.It looks like you're getting an error like out of storage space.Is there any good way?