Radio linktest not responding on 3602e Autonomous config for P2P Bridge
Hello there. Anyone have any ideas why my 2 3602e's are not showing linktest results? I am using them for a P2P bridge with a config I have used in the past. It could be a bug with the IOS version or a command I am missing. The configs are pretty basic and they can ping each other. Not sure why this is happening.
HippieBridge#ping 192.168.0.238 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 192.168.0.238, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms HippieBridge#sh dot11 associations
802.11 Client Stations on Dot11Radio0:
SSID [MichaelNET2] :
MAC Address IP address IPV6 address Device Name Parent State 8875.5657.c2a0 192.168.0.239 :: bridge CasaBridge01 self Assoc
This event was scheduled for September 23rd, but it has been moved to November 10 due to complex and unexpected circumstances. We apologize for all the issues this may cause.
Community Live- All Things LTE…4G, 5G and Whatever’s Next
(Live event - formerly...
Hello i have acces point 1815i cisco and we want installed in entreprise and we have camera surveillance wireless cisco so i want to know how much distance between ap 1815i and camera surveillance wi...
We want to broadcast a SSID (and allow users to connect) between certain times each day, and then take it offline. Unfortunately we dont have prime and only DNA Essential Smart licencing. All documents that I am seeing is that its possible if you have pri...
Hi all,I am looking for some guidance here, and I am quite certain that some of you, great minds, will be able to stir me in the right direction here. And a big thanks in advance. Here we go, i have three sites connected over private link MPLS....
Hi to all I purchase new AP C9120AXE converted to EWC.I notice when AP is booting a message related to default route not set that it says that can affect performance.Message is : %Default route without gateway, if not a point-to-point interface,...