02-25-2013 03:42 AM - edited 07-03-2021 11:36 PM
Hello everyone
Running vwlc 7.3.101 and encountered a smaller issue.
When you enable / disable a SSID, all AP's reset their radio interfaces... causing everyone to drop their connection.
Is this intentional?
Thanks
02-25-2013 04:35 AM
I have never ran into that issue at all. I make changes to specific eland and that doesn't affect any other wlans nor does it glitches the ap radios.
I do this all the time too.
Sent from Cisco Technical Support iPhone App
02-25-2013 04:36 AM
APs shouldn't rest their radios upon enabling or disabling ssid from WLC.
If the AP is autonomous , then adding or removing SSID to-from the radio interface causes it reset.
attach show run-config
highlight the APs that had resetted.
---------------------------------------------------------------------------
Please Don't to rate correct answers
02-25-2013 06:21 AM
Yeap, thats what I thought, couldnt remember having the AP's resetting their interfaces when enable/disable SSID'n
I will open a TAC case
I'll post the solution when I get it
Thanks for the replies
02-25-2013 07:13 AM
Clarification question. Are you using AP groups?
HTH,
Steve
------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: