04-19-2012 02:15 AM - edited 07-03-2021 10:01 PM
Dear all,
i noticed that the 1242AG does not bring up the Radios, when there is a Power Injector connected.
I see in the Logs of the AP:
%CDP_PD-2-POWER_LOW: All radios disabled - NEGOTIATED WS-C6509 <Switchport MAC Add>
The Module in the 6500 is a WS-X6348-RJ-45
The Option "Power Injector installed" on the WLC is also enabled, with the MAC Address from the Switchport, but no change.
When i disable CDP on the mentioned Switch Port and reload the AP, it comes up and runs fine.
Any ideas, what is causing this problem?
BR.
stefan
04-19-2012 04:40 AM
Isn't there another option on the wlc in regards to the power. IIRC, there are two options, try checking the other option.
Sent from Cisco Technical Support iPhone App
04-19-2012 07:55 AM
the other option is "override" in the field "Power Injector State".
but this didn't change the problem.
04-19-2012 05:18 PM
What is the WLC firmware?
04-19-2012 11:32 PM
WLC Soft is 7.0.116.0
AP Soft is 12.4(23c)JA2 / Boot Version 12.3.7.1
04-19-2012 11:37 PM
Is this the only WAP that's having a problem or are there more.
If this is the only WAP then check your cables.
04-20-2012 04:36 AM
yep, this is the only one.
will check the cables.
10-05-2012 06:01 AM
problem fixed, with replacing the power supply and cables.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: