08-31-2018 02:26 PM - edited 07-05-2021 09:04 AM
Good afternoon friends:
I have the following:
A WLC 2504, and a Cisco Prime version 3.1
Through the Cisco Prime I get backup of the different devices, including the WLC 2504. When my WLC 2504 died, I made my RMA; I already have the new WLC, but my question is how do I pass the backup of the Cisco Prime configuration to the new WLC? In Cisco Prime, I go to Inventory - Device Management --- Configuration Archive and I must do a DEPLOY, ?? it is right .?? or is there another way to do a configuration restore?
I await your help.
Regards.
Fernando.
08-31-2018 02:41 PM
Quick question, is this WLC 2504 in HA Pair ?
If so you can configure other device configuration and change the IP addresses.
08-31-2018 02:59 PM
Hello, this is not a WLC 2504 HA Pair.
09-01-2018 08:12 AM
Prime has the backup, so export that and upload it using TFTP or FTP, that is the easiest way I think. You still have to configure the initial stuff to get the device online. My suggestion is try to push “deploy” to the device and compare the config after that completes with an older config to see if everything got pushed. If not, uploading the config works 100%.
08-31-2018 05:57 PM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide