Hi,
Bit of an odd one here...
Configured an autonomous 1602 Access Point and connected to the LAN. Once connected it prevents users from outside the LAN connecting in. When the AP is set to DHCP, experience no issues at all. The config of the AP is below and as a workaround have added an ip route. Any ideas?
hostname XXXXX
!
!
logging rate-limit console 9
enable secret 5 $1$y7Fp$l3MW/v/u4slB82Wxlo/EZ/
!
no aaa new-model
ip cef
!
!
!
dot11 syslog
!
dot11 ssid xxxxx
authentication open
authentication key-management wpa version 2
guest-mode
wpa-psk ascii 7 106A5917550336484D573E78
!
!
crypto pki token default removal timeout 0
!
!
!
!
bridge irb
!
!
!
interface Dot11Radio0
no ip address
!
encryption mode ciphers aes-ccm
!
ssid xxxxxx
!
antenna gain 0
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
interface Dot11Radio1
no ip address
shutdown
antenna gain 0
no dfs band block
channel dfs
station-role root
bridge-group 1
bridge-group 1 subscriber-loop-control
bridge-group 1 spanning-disabled
bridge-group 1 block-unknown-source
no bridge-group 1 source-learning
no bridge-group 1 unicast-flooding
!
interface GigabitEthernet0
ip address dhcp
duplex auto
speed auto
bridge-group 1
bridge-group 1 spanning-disabled
no bridge-group 1 source-learning
!
interface BVI1
ip address 10.x.x.x 255.255.0.0
!
ip default-gateway 10.x.x.x
ip forward-protocol nd
ip http server
no ip http secure-server
ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
!
snmp-server community xxx RO
bridge 1 route ip
!
!
line con 0
line vty 0 4
login local
transport input all
!
end
