Please I'm new to cisco devices, but I have an issue in setting up an IP telephony network.
I have at my disposal a 2811 router, a 2960 cisco switch, one 7960 and a 7940 IP phone.
After having configured vlans, ip addresses, telephony services and dhcp on the switch and router, I noticed that the switch port (Fa0/13) on which the 7940 IP phone is connected does not come on. it completely shows no light.
And curiously, the light in question lights up whenever the switch boots up.
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 18.104.22.168, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...
Hey Guys,I Have several 1600 Series AP's (AIR-CAP1602I-ZK9) that was working with WLC before, I changed them with 1800 series but would like to use 1600 Access Points series independently and without WLC for somewhere else, so I want to know do they...
This event was scheduled for September 23rd, but it has been moved to November 10 due to complex and unexpected circumstances. We apologize for all the issues this may cause.
Community Live- All Things LTE…4G, 5G and Whatever’s Next
(Live event - formerly...