slow reply times from client (Handheld Dolphin 9550)
Hello all good people,
last time I have a problem with Dolphin scanners with long reply times.
I have four scanners directly under AP (AIR-LAP1242-E-K9, two dipole antennas). One has reply around 60ms, second the same, third around 500ms and the last one about 2500ms. All the scanners are running the same configuration with powersave mode disabled. Security is set to WPA-PSK with 63 chars long key.
We have one central controller, where are all the APs connected. Other locations do not have this problem.
I walked around with Ekahau, Spectrum and Airmagnet and found no interference or other interrupting devices.
Have somebody any ideas what can be cause of this problem?
Controller is running firmware 188.8.131.52
Ping replies, Signal strenght and SNR is attached.
It would appear to me that this issue is more than likely Terminal based and not Cisco based..? I would recommend you test the drivers on the 9550 and ensure they are all up to the lastest, one other thing is to try different AP Threshold settings on the Terminals and check to ensure it is Authenticating OK via the supplicant and not dropping in and out of Authtentication?
Hi, My customer wants to Download a report of users with MAC addresses who logged in June 2020. He is using PRTG but that Server is not connected with WLC. What we need to do to achieve this goal? Thanks in advance. Regards,Waqas
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 184.108.40.206, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...