SRE Wlan configuration

[dumisanid]

Hi

I purchased a cisco2901 and added a SRE so as to add the WLAN module. I need to know If any of you have ever had to configered this bo know how before.

I just need to know how we unable Http access from the CLI for the WLAN module.

regards

[George Stefanick]

can you post the show run ? On a normal ap its

[dumisanid]

this is show run output from the SRE module

System Information

Manufacturer's Name.............................. Cisco Systems Inc.

Product Name..................................... Cisco Controller

Product Version.................................. 7.0.116.0

RTOS Version..................................... 7.0.116.0

Bootloader Version............................... 7.0.116.0

Emergency Image Version.......................... 7.0.116.0

Build Type....................................... DATA + WPS

System Name...................................... Cisco_6a:8d:c0

System Location..................................

System Contact...................................

System ObjectID.................................. 1.3.6.1.4.1.9.1.1230

IP Address....................................... 192.168.4.10

System Up Time................................... 0 days 0 hrs 22 mins 41 secs

System Timezone Location.........................

Current Boot License Level....................... base

Current Boot License Type........................ Permanent

Next Boot License Level.......................... base

Next Boot License Type........................... Permanent

--More or (q)uit current module or to abort

THIS IS THE RUNNING CONFIG on THE ISM INTERFACE

interface ISM0/0

ip address 192.168.4.1 255.255.255.0

service-module ip address 192.168.4.10 255.255.255.0

!Application: Running

service-module ip default-gateway 192.168.4.1

end

BUT MY PING to 192.168.4.10

Lodge_Router#ping 192.168.4.10

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 192.168.4.10, timeout is 2 seconds:

.....

Success rate is 0 percent (0/5)

Can you guys shed some light in to this?

[Saravanan Lakshmanan]

HTTPs is by default enabled on SRE module.

WLC>show network summnary -- Look for web mode and check the status.

WLC>config network webmode enable

ISM0/0 is to pull the software package for SRE, use ISM0/1 for wireless.

interface ISM0/0

ip address 10.1.1.2 255.255.255.0      !Service module host side IP address

ip nat inside  !To establish connectivity between SM and outside network for installation

ip virtual-reassembly in

service-module ip address 10.1.1.3 255.255.255.0 !Needed for WLC installation

!Application: Running

service-module ip default-gateway 10.1.1.2       !Host side IP address

hold-queue 60 out

!

interface ISM0/1

description Internal switch interface connected to Internal Service Module

switchport mode trunk    !Used for connectivity to Wireless Controller after installation

SRE on Router can be deployed/support different scenarios.

http://www.cisco.com/en/US/docs/wireless/controller/controller_modules/sre/installation/guide/wlcsreinst.html