TDOA Receivers - and Coverage maps in CPI

[nh6we]

Using Cisco Prime, within the site MAPS, I got this message "There aren't any APs/WiFi TDOA Receivers placed on the map.  The map will not refresh until at least one AP/ WiFi TDOA Receiver is placed on the map

Any ideas

[Saurav Lodh]

Could be Bug below

Clients are loaded only when APs are seen on the maps

CSCtz24343

With no workaround mentioned.

[Abhishek Abhishek]

Process	Description
1. Add a new campus/building map	Choose Monitor > Site Maps . From the Select a command drop-down list, choose New Campus or New Building .
2. Add a floor map	Choose Monitor > Site Maps . From the Select a command drop-down list, choose New Floor Area.
3. Use Map Editor	Choose Monitor > Site Maps . From the Select a command drop-down list, choose Map Editor.