Trouble getting a DHCP address behind a wireless bridge
I have a Ubiquity Pico Station M2 in bridge mode basically acting as a wireless card to the device that is connected to it with a patch cable. Both the Pico Station and the device connected to it are set for DHCP. In one building I have some old stand alone Cisco 1130AG AP's that are directly connected to a Cisco layer 3 switch with DHCP server on it. The Pico Station can join the wireless network and get an IP from the DHCP server. Once this completes, the device attached to the Pico Station with a patch cable can also get a DHCP address through the Pico Station. No Problems here.
The problem arises when I have the exact same setup with the Pico Station and the device, but in the 2nd building I have a 2504 lan controller utilizing Cisco 2602's also connected to a Cisco layer 3 switch with DHCP server on it. The Pico Station will acquire a DHCP address without issue. But the device attached to the Pico Station fails to acquire a DHCP address. Is there something with the lan controller and 2602's that don't allow this kind of pass through?
I tried having the lan controller set to DHCP proxy and without the DHCP proxy. Neither one will work.
This tool is essentially used to generate basic and best practice configurations for the 9800 Controller. The basic configurations include Day 0 Config, Central and Local Webauth, Dot1x, PSK etc. The tool uses a GUI format to take input variables for the ...
The Workplace, Reimagined: Secure Network Solutions for Business Resiliency
Network Insider Live Webinar
Tuesday, August 18, 202010:00 am Pacific Time(San Francisco, GMT-08:00)
Where and how your employees work is changing—your workforce can...
Do you have hands-on experience with wireless network management?
If yes, please participate in this quick online survey. We'd like to understand your wireless network management and job roles that partake in this task. Your feedback will be reviewed a...
This event had place on Thursday 11, June 2020 at 10hrs PDT
In this session, the Cisco expert covered single image orchestration changes with the Cisco IOS XE Software Release 17.2.1r for Cisco IOS XE and Cisco IOS XE SD-WAN use cases. Duri...
This is a two-step process.
Step 1: Need to add the FlexConnect AP to a FlexConnect Group.Step 2: Need to configure a FlexConnect ACL (to specify the local traffic-of-interest), and map it to that FlexConnect Group.
For step 1----------As in the i...