I only did this a few weeks ago and it was easier, but today I can't reset another spare AP and set it to autonomous. I was originally connected to our WLC so I've consoled in and removed the config.txt and the private-multiple-fs anre rebooted:
But my command to add the correct firewall doesn't work am I in the wrong mode?
QuestionI have the following Air AP:Air-AP1562I-B-K9, 802.11ac outdoor access point There are three antenna cables that go from the inside cover to some soldered connections on a PCB. When removing the cover, two of the soldered antenna connections c...
QuestionHiWe have a guest access set up and was wondering what exactly are the sequence of events from connecting to SSID to being granted internet access, see below steps I'm unsure of are left blank1. connect o SSID through AP2. traffic hits Foreign WLC...
Model:C9120AXI-Q Install EWC on C9120 running with CAPWAP as shown in the attached log, but the installation fails.It looks like you're getting an error like out of storage space.Is there any good way?