I have just recently purchased this device on ebay as a used product from a bankrupt company, which was selling off old equipments. I am trying to attempt to console into the ap, but am not able to do so, sucessfully. I am using a usb type console to blue rollover cable on com3. I have the power injector plugged in. However, the status light is blinking only. I have tried to use putty to get into the ap, but nothing happens as I tried to use serial, com3, 9600 baud, 8 data bits, 1 stop bits, none pairty, and flow controle none. It doesn't sucessfully load. Am I doing something wrong here? I even tried the mode button to reset the ap as well and it doesn't help at all. I hope someone here can help me with this?