Vlan tagging via CLI WIFI

[T_M_S_W]

Hi,

Ive got a number of 1117's with wifi to configure and id preferably not use the gui to do it. I need to tag vlan 10.

I have been able to work out the config I need to apply to the controller for the most part apart from Vlan tagging. Any idea how to turn that on and apply the vlan via cli on the controller?

Basically page 218 and 219 in the below guide I want to be able to do in cli. Any help would be appreciated.

https://www.cisco.com/c/en/us/td/docs/routers/access/1100/software/configuration/xe-16-7/cisco_1100_series_swcfg_xe_16_7_x.pdf

[TsvetanVladimirov81607]

Hi,

Would you mind showing the current Wireless config that you have.

I am also trying to figure a way not to use the GUI, even though it is easy enough.

Thanks

[Rich R]

In gerenal if you can't find instructions for CLI then just do it on GUI and see what CLI config is added to the config then you know what the correct config is for future ;)

[T_M_S_W · Accepted solution]

Coming back to this so hopefully it helps others the command I was looking for was

config flexconnect group default-flexgroup wlan-vlan wlan 1 add vlan 10

More info can be found here

https://www.cisco.com/c/en/us/support/docs/wireless/mobility-express/212484-configure-flexconnect-vlan-mappings-on-m.html#anc6