WAP200 Access Point Firmware

[MrBryce2000]

Greetings, I have a Linksys WAP200 Rev.01 access point. I currently have firmware version 1.0.22 installed. The only firmware that I can find on the Cisco support site is version 2.0.6.0. According to my previous experience with access points in general, Rev.01 of a device can not run version 2 of the firmware. Is that still true, or will I be able to upgrade the firmware on my access point to version 2?

Thank you for your time.

[Ravi Singh]

Hello Bryce,

You cannot upgrade LinksysWAP200 Rev.01 to Version 2.

[chris-f-linksys]

Hello Ravi,

I'm looking for source code for the AP WAP200 version 2.0.6.0.                     

I found only the source code for the version WAP200_GPL_v2.0.4.0_PUB_200110801.tar.bz2                                

I'm already registration.                                            

Can you help me and send special link to may registered email?                                                                                                                                           
                                                                                                                                                           
Thank you in advance.