There are two each WAP2000, one with external/outside antennas in a building with wire network connectivity, the other WAP2000 is a repeater in another building. The repeater is dead due to a failed firmware update. No connectivity, nothing, old IP or default IP.
Questions; 1) are there any other repairs possible for the dead unit other than the reset which is not working? 2) What is a recommended replacement for the repeater WAP2000 that will function as a repeater and connect to the other wired WAP2000? 3) If both units have to be replaced, what is a recommended replacement for the above configuration?
I have a few AIR-CAP3502E-A-K9 access points that I want to change to Lightweight mode. I did a lot of researching and found that I needed the ap3g1-k9w7-tar.153-3.JAB.tar file or a similar version of it.I do have that file and I was able to upload ...
WLAN Poller provides functionality to:
Bulk data/debug collection from Controllers and APs. Execute the commands on regular intervals.
DFS statistics and debug collection
IOS AP Flash health check and memory
AP cert check with generating reports
My report tells you a simple viewpoint to understand the evolution of the wireless LAN from 1997 to the 2020s. You can also get basic knowledge on an uplink of Wi-Fi6, the latest IEEE 802.11ax standard. Data analysis results based on our experimental s...
WLAN controller newb here. A power outage took out my home network but upon return my two SSIDs came back and my three APs went blue... everything WiFi related was working as expected. Sometime later I logged into the WLAN Controller web-page to see I hav...