I try to configure a WGB in autonomous mode to connect to a lightweight access-point. I followed the cisco paper about it and my wgb associate well to the AP on the asked SSID. From the wgb i can ping stations behind the lightweigth access point so the association is OK. My problem is wired stations behind the WGB cannont ping.
The ap use H-REAP mode with mutli-ssid. I want wgb for only one ssid.
This tool is essentially used to generate some basic configuration for the 9800 Controller. The basic configurations include Day 0 Config, Central and Local Webauth, Dot1x, PSK etc. The tool uses a GUI format to take input variables for the specific use c...
The Workplace, Reimagined: Secure Network Solutions for Business Resiliency
Network Insider Live Webinar
Tuesday, August 18, 202010:00 am Pacific Time(San Francisco, GMT-08:00)
Where and how your employees work is changing—your workforce can...
Do you have hands-on experience with wireless network management?
If yes, please participate in this quick online survey. We'd like to understand your wireless network management and job roles that partake in this task. Your feedback will be reviewed a...
This event had place on Thursday 11, June 2020 at 10hrs PDT
In this session, the Cisco expert covered single image orchestration changes with the Cisco IOS XE Software Release 17.2.1r for Cisco IOS XE and Cisco IOS XE SD-WAN use cases. Duri...
This is a two-step process.
Step 1: Need to add the FlexConnect AP to a FlexConnect Group.Step 2: Need to configure a FlexConnect ACL (to specify the local traffic-of-interest), and map it to that FlexConnect Group.
For step 1----------As in the i...