We have a WLC 2106. We would like to set up a WiFi access point that would allow users (employees and guest) to connect only if they are provided a dedicated user name and password. The system we are after would be similar to that often found in hotels and ideally we would be able to create time bound links for guests. We also need the access point to record user authentication logs so that we can match the respective users to the Internet access under the IP assigned, to the traffic recorded on our main gateway for the same IP.
Would the WLC 2106 support this requirement? What additional components would be required?
For all these things you need to have a ISE(Radius server).
Cisco Identity Services Engine (ISE) is a security policy management and control platform. It automates and simplifies access control and security compliance for wired, wireless, and VPN connectivity. Cisco ISE is primarily used to provide secure access and guest access.
I have a few AIR-CAP3502E-A-K9 access points that I want to change to Lightweight mode. I did a lot of researching and found that I needed the ap3g1-k9w7-tar.153-3.JAB.tar file or a similar version of it.I do have that file and I was able to upload ...
WLAN Poller provides functionality to:
Bulk data/debug collection from Controllers and APs. Execute the commands on regular intervals.
DFS statistics and debug collection
IOS AP Flash health check and memory
AP cert check with generating reports
My report tells you a simple viewpoint to understand the evolution of the wireless LAN from 1997 to the 2020s. You can also get basic knowledge on an uplink of Wi-Fi6, the latest IEEE 802.11ax standard. Data analysis results based on our experimental s...
WLAN controller newb here. A power outage took out my home network but upon return my two SSIDs came back and my three APs went blue... everything WiFi related was working as expected. Sometime later I logged into the WLAN Controller web-page to see I hav...