cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

Community Helping Community

113
Views
0
Helpful
2
Replies
Highlighted
Beginner

Wireless Control System - Unsupported (Other) Antennas

I have been configuring Cisco WCS 7.0.230. I have five controllers (5508's) and over 300 AP's. We have a mixture of AP's but mostly 1142n's, with some 2602i and 702w's. We decided to monitor this all using WCS as we want to develop a process of upgrading the 1142n's with 2602i's in highest traffic area's first. When we use the mapping software and try to get RF predictions we get the following message

RF Prediction will not be computed for the following AP's
since these AP's have Unsupported (Other) Antennas.
Are you sure you want to continue?

AP_203(802.11b/g/n), AP_203(802.11a/n),
AP_210C(802.11b/g/n), AP_210C(802.11a/n)

What do I need to do to get the WCS to recognize these newer Cisco Ap's? We have added 702w in some classroom and NEED the RF Prediction to help ensure that coverage is complete. Any suggestions would be helpful

Everyone's tags (1)
2 REPLIES 2

You would need to migrate to

You would need to migrate to NCS to support the newer models of AP and WLC code.

 

http://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/2-2/release/notes/cpi_rn.html#56742

 

HTH,

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
Beginner

It was my understanding that

It was my understanding that the  WCS was a module of the Prime Infrastructure and that it could be migrate to PI without additional cost, so the only way to identify Cisco AP's antenna's on Cisco own software is to update to new software that offers us services that we don't want? There must be a way to identify these antenna's even if I need to create custom templates or something.

CreatePlease to create content
Content for Community-Ad

August's Community Spotlight Awards