WiSM module not coming in OPER-UP status

[MICHAEL BURNS]

The problem is WiSM module not coming in OPER-UP status , it’s in  Started-Keepalive status.

I did run debug wism events on cat6509 and seeing below logs:

Aug 17 05:16:02.930: WiSM-Evt:dman_cntrl_db_search_by_mac: Found mac 30e4.db38.9981 for slot/port 8/1

Aug 17 05:16:02.930: WiSM-Evt:dman_reg_arp_added: cntrl 8/1 got an ip 1.1.1.3 30e4.db38.9981/30e4.db38.9981

Aug 17 05:16:02.930: WiSM-Evt:dman_reg_arp: received a garp from 1.1.1.3/1.1.1.3

Aug 17 05:16:02.930: WiSM-Evt:dman_cntrl_db_search_by_mac: Found mac 30e4.db38.9981 for slot/port 8/1

Aug 17 05:16:02.930: WiSM-Evt:dman_reg_arp_added: cntrl 8/1 got an ip 1.1.1.3 30e4.db38.9981/30e4.db38.9981

Aug 17 05:16:06.870: WiSM-Evt:dman_proc_keepalive_tmr_handler: keepalive timer expired for 8/1

Aug 17 05:16:06.870: WiSM-Evt:dman_cntrl_db_search: something wrong 15

It’s receiving garp request from controller and assign ip to controller but then keepalive time expired and it’s put the controller in started-keeplaive status.

Not sure what’s happening exactly.

[Amjad Abdullah]

What causes the problem to happen? It seems your wism module was ok before so what happened and caused tios issue

Sent from Cisco Technical Support iPad App

[Leo Laohoo]

Can you please post the command:  sh wism 8 controller 1 status

[MICHAEL BURNS]

By the way, this is a  new install...

JP2-RDC-COR-01#sho wism module 8 controller 1 status

WiSM Controller 1 in Slot 8 configured with auto-lag

Operational Status of the Controller : Started KeepAlive
Service VLAN                         : 93
Service Port                         : 3
Service Port Mac Address             : 30e4.db38.9981
Service IP Address                   : 1.1.1.3
Management IP Address                : 0.0.0.0
Software Version                     :
Port Channel Number                  : 415
Allowed-vlan list                    : 90,800,810
Native VLAN ID                       : 90
WCP Keep Alive Missed                : 0

[Leo Laohoo · Accepted solution]

Ok, so what is the output to the command "sh etherchann 415 summary"? 

Wait a sec ... No Software Version???

Did you try to console into the WiSM line card?

On the 6500, can you post the output to the command "sh module"?