I am trying to run the WLAN poller tool against WLC 5520. User authentication is via ACS. I am using AAA credentials for the poller tool to authenticate for WLC and AP. But when I run the tool, i see error message that the WLC failed to respond.
Is there any way to increase timeout for the WLC authentication in the poller tool .ini file?
Any help is much appreciated.
Can't change the timeout, but make sure that you have the WLCs information correct in the file. Check if the IP is set correctly, the poller might just not be able to reach it. See if the ACS is able to register someone attempting to authenticate to the WLC.
ran it against a WLC with TACACS auth and it works fine with no tweeks to the script other than the WLC details and credentials.
While working with the TAC engineer, I found that the logon timer is set for 15 secs in the libCuwn.py file. Our issue was the WLC would expect an additional new line character to be entered manually before it could accept the credentials for successful logon.
TAC engineer suggested for a little modification within the libCuwn.py file to get around the problem. This new script will be tested soon. Will post the outcome accordingly.