09-15-2020 06:27 AM - edited 07-05-2021 12:30 PM
Dear All,
i have a cisco 5508 wireless controller suddenly it stopped working and started giving below led status.
SYS blinking amber - ALM continuous amber on and power supply LED OFF.
i am not able to console the device as well.
did anyone face this issue and what was the solution.
Solved! Go to Solution.
09-15-2020 06:49 AM
Contact Cisco TAC and organize for an RMA. The appliance is dead.
09-15-2020 06:54 AM
If you do not have concole access, we can do muich help here, if you have contract with cisco (raise TAC case for replacement).
09-16-2020 12:55 AM
Issue was with the power supply unit got the PSU replaced and now working fine.
09-15-2020 06:49 AM
Contact Cisco TAC and organize for an RMA. The appliance is dead.
09-15-2020 06:54 AM
no other solution other than RMA? i think cisco stopped supporting this device.
09-15-2020 06:54 AM
If you do not have concole access, we can do muich help here, if you have contract with cisco (raise TAC case for replacement).
09-15-2020 06:57 AM
unfortunately, i dont have access to console as well and no contract
09-15-2020 07:05 AM
Most probably time to retire the kit and move to new model or look for refubished if you like to.
09-16-2020 12:55 AM
Issue was with the power supply unit got the PSU replaced and now working fine.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide