03-05-2009 12:09 AM - edited 07-03-2021 05:16 PM
hi, all!
i try to find an answer if wlc can advertise not all ssid to the lap's. how can i setup this feature?
for example - i have 10 LAPs over the building and 5 SSID's.
i need to advertise only 3 SSID at the 1 floor and all of them at the second floor.
is it possible?
ps sorry for my bad english ))
Solved! Go to Solution.
03-05-2009 02:34 AM
Hi Vadik,
Yes it's possible - in version 4 you would use WLAN override. Basically in the radio config of each AP you can select WLAN override, and then check the WLANs that you want to advertise.
In version 5 you would use AP groups.
I've found this quite helpful:
http://www.cisco.com/en/US/docs/wireless/controller/4.0/configuration/guide/c40wlan.html#wp1114777
J
03-05-2009 02:34 AM
Hi Vadik,
Yes it's possible - in version 4 you would use WLAN override. Basically in the radio config of each AP you can select WLAN override, and then check the WLANs that you want to advertise.
In version 5 you would use AP groups.
I've found this quite helpful:
http://www.cisco.com/en/US/docs/wireless/controller/4.0/configuration/guide/c40wlan.html#wp1114777
J
03-05-2009 05:27 AM
thanks a lot!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide