01-24-2012 04:59 AM - edited 07-03-2021 09:26 PM
Hello,
I want to deploy two wlc 5508 running Software Version 7.0.116.0 in failover mode.
I read the documentation and I read that the two wlc must have the same configuration.
I want to be sure that I've well understood.
For all the interfaces, each appliance must have a different IP. I mean if WLC1 have the interface "ap-manager" "management" and "dynamic interfaces" in .1, I suppose that WLC2 should have the same interfaces with .2 IP.
Am I right?
By advance thanks
01-24-2012 05:03 AM
The 5508 does not have an ap-manager unless you specifiacally create one. I would not create one and use the default management interface.
Yes the WLC's should have the exact same config, except for the interfaces ip address and of course the hostename.
Hostname: WLC1
Management IP: 10.200.100.5
Virtual: 1.1.1.1
Dynamic Interface 1: 10.200.105.5
Dynamic Interface 2: 10.200.110.5
Hostname: WLC2
Management IP: 10.200.100.6
Virtual: 1.1.1.1
Dynamic Interface 1: 10.200.105.6
Dynamic Interface 2: 10.200.110.6
01-24-2012 05:47 AM
Ok thank you for your quick help.
It wasn't so explicit in the documentation
01-24-2012 05:50 AM
No problem.
01-24-2012 06:09 AM
keep in mind that you need to share a mobility group as well.
Sent from Cisco Technical Support iPhone App
04-23-2013 12:26 PM
Please check the docs to configure WLAN Controller failover:
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide