10-28-2018 09:59 AM - edited 07-05-2021 09:22 AM
Hello guys,
I have 2 WLCs 5508 on which I would like to enable HA SSO functionality. But, I have a problem. I can't activate the WLC's RP ports. The RP ports are connected through L2 switches. On these switches, the RP ports always remain in the "notconnect" state.
What could be the cause? What is the speed/duplex I should set by default?
Regards,
Ayoub.
10-28-2018 11:05 AM
what is the version of code running in WLC.
can you post show port summary also switch side port configuration.
10-28-2018 12:13 PM
10-28-2018 02:19 PM
10-30-2018 09:07 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide