cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
604
Views
0
Helpful
1
Replies

WLC2504 - New AP caused excessive broadcast

Maddin B
Level 1
Level 1

Hello,

I have the problem when I install a new AP that is causing a broadcast in the VLAN frome the AP.

This broadcast is so strong that there are disconnections and other devices also start a broadcast.
Broadcast requests are requests for IP addresses "How has xxx?"

Is this a loop problem in this vlan?

1 Reply 1

What is the subnet size of that vlan you place APs ? Typically AP use L3 broadcast as one method of discovering WLC. You should not have such impact if it is reasonable size broadcast domain (eg /24,/23)

 

HTH

Rasika

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card