WLCCA 4.1(6) - 30037,General: Non default RRM timer in use (CHA)

[markus.forrer]

Hello

I just run WLCCA against a WLC running 8.0.121.0

I got the following errors:

30037,General: Non default RRM timer in use. This is not recommended unless directed by Cisco support. Coverage Hole Interval 11a:90

30037,General: Non default RRM timer in use. This is not recommended unless directed by Cisco support. Coverage Hole Interval 11b:90

But regarding this RRM Whitepaper 90s is the default timer for.

Am I right?

Markus

[Javier Contreras]

hi Markus

yes!

just checked on WLC code, on 7.x it was 180, but on 8.x it was updated to 90 sec, as part of improvements done on RRM calculations

I will modify the value on WLCCA for upcoming 4.2 release, thanks for reporting

regards

[Javier Contreras · Accepted solution]

BTW, beta version of 4.22 is now available with the fix, in case you want to give it a try

[markus.forrer]

Hi Javier

The beta of 4.22 fixed this.

[Javier Contreras]

good, thanks for confirming!