cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1363
Views
0
Helpful
4
Replies
Enthusiast

WLCCA 4.1(6) - 30037,General: Non default RRM timer in use (CHA)

Hello

I just run WLCCA against a WLC running 8.0.121.0

I got the following errors:

30037,General: Non default RRM timer in use. This is not recommended unless directed by Cisco support. Coverage Hole Interval 11a:90
30037,General: Non default RRM timer in use. This is not recommended unless directed by Cisco support. Coverage Hole Interval 11b:90

But regarding this RRM Whitepaper 90s is the default timer for.

Am I right?

Markus

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

BTW, beta version of 4.22 is

BTW, beta version of 4.22 is now available with the fix, in case you want to give it a try

View solution in original post

4 REPLIES 4
Cisco Employee

hi Markus

hi Markus

yes!

just checked on WLC code, on 7.x it was 180, but on 8.x it was updated to 90 sec, as part of improvements done on RRM calculations

I will modify the value on WLCCA for upcoming 4.2 release, thanks for reporting

regards

Cisco Employee

BTW, beta version of 4.22 is

BTW, beta version of 4.22 is now available with the fix, in case you want to give it a try

View solution in original post

Enthusiast

Hi Javier

Hi Javier

The beta of 4.22 fixed this.

Cisco Employee

good, thanks for confirming!

good, thanks for confirming!

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards