cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
218
Views
5
Helpful
3
Replies
Highlighted
Beginner

RESTconf issues in IOS-XE

Hi All,

 

I cannot config the service-policy for the port-channel subinterface using RESTconf in CSR1000V.
Also, There was no service-policy information in the GET even if it was configured in the CLI.
I am trying CSR1000V, IOS-XE16.12.3.

 

=====================
〇CLI Config
interface Port-channel1.1000
  encapsulation dot1Q 1000
  ip address 100.100.100.1 255.255.255.252 
  service-policy output TEST_policy ★target config

〇Result of GET
{
  "Cisco-IOS-XE-native:Port-channel-subinterface": {
    "Port-channel": [
      {
        "name": "1.1000",
        "encapsulation": {
          "dot1Q": {
            "vlan-id": 1000
          }
        },
        "ip": {
          "address": {
            "primary": {
              "address": "100.100.100.1",
              "mask": "255.255.255.252"
            }
          }
        }
      }
    ]
  }
}

=====================

 

If service-policy is config to GigabitEthernet subinterface or port-channel, the problem does not occur.

 

I would like to configure the settings for ASR1001-HX as well. Will the same problem occur for ASR?
Is there any solution to this problem?

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted

Hello alexstev

 

Thank you for your reply.

When I contacted CIsco TAC, I found that it was not supported.
We have received the answer that this will be implemented in future OS as an enhancement.

View solution in original post

3 REPLIES 3
Highlighted
Cisco Employee

 

Hello @m-hosaka,

 

Welcome! I'm not an expert with this particular technology, although I have worked with this class of router and software previously. Here are my insights:

 

These might not give you the answer you're looking for but at least may give you some ideas and point you in the right direction. I hope this helps.

Highlighted

Hello alexstev

 

Thank you for your reply.

When I contacted CIsco TAC, I found that it was not supported.
We have received the answer that this will be implemented in future OS as an enhancement.

View solution in original post

Highlighted

 

Thank you for giving us the solution @m-hosaka !

Content for Community-Ad