I am looking to purchase a 2n Hellios IP Force equipped with a card reader. Based on the documentation it supports a wiegand 3 wire configuration. Currently we have cisco physical access gateway CIAC-GW-K9 deployed. Is it possible to wire the 2n 3 wire wiegand to the access gateway?
The access control guides makes reference to a 10 or 3 pin wire configuration.
As you can see http://en.wikipedia.org/wiki/Wiegand_interface wigand used only three wires. Cisco Gateway officialy supported 5-wire reader connection. I think 2n readers used 4 wire minimum: 12v,DATA0,DATA1,Ground. You can try to connect it on 4 wire to GW.
ISE 2.7 Guest Access Management Features
The following document explains the guest features of ISE 2.7. For more detail of what ISE 2.7 has to offer please check the associated documentation.
Auto Login on Sponsor Approval
SymptomsOutage during FTD code upgrade DiagnosisThe FTD code upgrade thru FMC will cause the traffic interruptionSolutionBelow process will upgrade the FTD with no downtime and no traffic interruption.Before the upgrade process:Download the FTD platf...
Process for FTD migration with PolicyAs per Cisco documentation, we have below steps for for de-register and register process. Please follow below steps :Step 1 : Break HA pair and de-register your FTD from FMC (old).Step 2 : Register your primary FTD wit...
Hi There,Is there a relationship between the hardware of the Cisco ASA 5505 FWs (V02) and the 9.x software version? Multiple ASA have been successfully updated with the same software. The ASAs that have been updated without any problems are V06 versi...
Dear Cisco Customers and Partners,
We know that the Cisco Identity Services Engine (ISE) is a critical element of your network security and so stability is of paramount importance. As a result, many of you asked us for a suggested release given sev...