Physical Security

While reading through the Securing Cisco Video Surveillance Manager Release 6.x: Best Practices and Recommendations document on cisco.com and comparing TAC testing results, we discovered an inaccuracy in the published document.Note that the UDP range...

Greetings Cisco community,I was hoping if someone could provide with some examples of security issues which pertain to the physical layer of the OSI model.I am aware of Switch flooding, where an attacker can overflow the switch's address table with f...

In my organization, the loss prevention group very often downloads archive clips to a local PC that are quite long: 1-4+ hours. Review is done offline - fast forwarding thru the clip or using smartsearch. Even if the PC is attached to the same local ...

I'm unable to install VSOM 6.3 client on Windows 7 64 bit, Client install program gets stuck in a loop, 4.2 worked fine in Windows 7 64 bit.

Hi,I am trying to upgrade CIVS-IPC-2500 firmware from 1.1.x to 2.1.x, but after the upgrade, I was unable to https to the ip camera, nor that i can ssh to it. Should I try to load the firmware again, how to do it?regards,yeo

Let's put it to rest!This is effectively a re-hash of the issues outlined here:https://supportforums.cisco.com/message/3478938#3478938I'm opening a new thread to spur discussion, plus I'd like to test out this "open an SR from a discussion" capabilit...

Hello,I am using Cisco IPICS server 4.0 (2) and have installed total of 12 LMR gateways so far. I have uploaded 18 LMR gateway license in IPICS but it says that 18 are used and no free license for new LMR but i have registered only 12.IPICS server = ...

We have a decent install of VSOM, 16 cams (1 HD & 15 SD) and up until a recent upgrade we had random VSOM client feeds (16up) come up as black, like i said, randomly, hit F5 it may show the video on that feed and another feed come up black, or any mi...

Hello All,We have recentrly upgraded our VSMS,VSOM servers to 6.3.2I have noticed that i cannot view any video feed through the VSOM for all the 2421 SD cameras,all we see is a black sreen with no error messages. In contrary, i can see the video feed...

I have a camera that is displaying everything in a "Red" tint. I have ever seen anything like this nor could I find anyother other cases so I'm turning to here to see if I should try to get it replaced.  When I put the camera in "Night Mode" it looks...

Hiwe are going to install and configure IP camera 4500 that support video analytics to use it for some purposes in the customer site and i have some questions regarding the video analytics part:1- i tried to configure tripwire rule to detect persons ...

the 250GB hard drive in the cpam server started giving bad sector messages so I swapped in a new one, used the .iso image for 1.2.0 and re-imaged the machine, no problems. I tried the restore procedure as outlined in the doc using the last known good...

Hi2all !We use Cisco Video Surveillance Operations Manager Software 6.3.2 on the servers of MSP 4RU for organization of Video Surveillance. We use a few ip cameras among that there is cisco ip camera 2935. Cameras support patterns (not presets!). How...

How can you set up VSOM to email you an alert when a camera goes into the down state?Thanks,Robert Greeson