cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1782
Views
0
Helpful
2
Replies

Can i connect Merki MR33 to Cisco FTP ?

We have 6 devises of Merki MR33 now connected to Meraki MX64, but we need to change that Meraki to  Cisco Firepower 1010 

Can we connect the AP's MR33 ? and if yes please share any gide will be appreciated

1 Accepted Solution

Accepted Solutions

Hello


@HaniAbuelkhair6735 wrote:

We have 6 devises of Merki MR33 now connected to Meraki MX64, but we need to change that Meraki to  Cisco Firepower 1010 

Can we connect the AP's MR33 ? and if yes please share any gide will be appreciated


Unless the FP supports POE no you cannot, if they do support POE or your able to use power injectors for the AP's or connect them to a POE switch behind the FP then yes.
The meraki APs need to be reachable to/from the meraki dashboard so you would need to open up the specific ports on the FP to the internet to accommodate.-  Here



 

 


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul

View solution in original post

2 Replies 2

balaji.bandi
Hall of Fame
Hall of Fame

looks your requirement not make any sense ? explain more and tell us who proposed this config ?

 

MR33 register with  MX will connect to meraki cloud, so you want introduce fw(ftd) mx and cloud ?

#

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Hello


@HaniAbuelkhair6735 wrote:

We have 6 devises of Merki MR33 now connected to Meraki MX64, but we need to change that Meraki to  Cisco Firepower 1010 

Can we connect the AP's MR33 ? and if yes please share any gide will be appreciated


Unless the FP supports POE no you cannot, if they do support POE or your able to use power injectors for the AP's or connect them to a POE switch behind the FP then yes.
The meraki APs need to be reachable to/from the meraki dashboard so you would need to open up the specific ports on the FP to the internet to accommodate.-  Here



 

 


Please rate and mark as an accepted solution if you have found any of the information provided useful.
This then could assist others on these forums to find a valuable answer and broadens the community’s global network.

Kind Regards
Paul
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: