Tool does allocate IP address to a single 2500 camera however nothing is displayed in the discovery tool. Only one interafce is enabled and the rest are disabled. Local interface does have ip address of 192.168.0.2/24. What am I missing? Also what would be the best logical procedure in configuring 20 camera, i.e bulk configuration? If the camera is plugged into a Cisco switch and DHCP is enabled then by default (Out of the box) will CDP discover this on the switch and tell me its IP address details by show cdp nedighbours detail or do I have to enable CDP on the camera before it displays layer 3 configuration?
