cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1591
Views
5
Helpful
5
Replies
Highlighted
Beginner

Cisco PAM Badge Designer Barcode

We have recently installed Cisco Physical Access Manager V1.2.0. We are using

the included Badge Designer from Glips Graffiti Editor v1.4. Has anyone had any

luck adding a 3 of 9 barcode to the badge design?

Thanks,

Devin

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

Yes, I have attached a document showing the steps to use a custom font with the Badge Designer.  In the doc, it shows usind the 3of9 barcode font as an example.

Hope this helps,

Mike

View solution in original post

5 REPLIES 5
Highlighted
Cisco Employee

Yes, I have attached a document showing the steps to use a custom font with the Badge Designer.  In the doc, it shows usind the 3of9 barcode font as an example.

Hope this helps,

Mike

View solution in original post

Highlighted

Michael,

     Thank you so much for your reply this is just what we were looking for...

Highlighted

Mike,

That is super!!  Thanks so much for your help with this issue. I have done quite a bit of work on UC with phone integration to CPAM.  Please feel free to reach out to me at anytime with questions on this topic or others.

Best Regards,

Mark Bailey

Highlighted

Mike,

Just finished testing.  Worked like charm.  You are the man!

Highlighted

Yes, Mike has always been 'the man' when it comes to CPAM.

Thanks Mike!

Jim

This widget could not be displayed.