cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2129
Views
5
Helpful
5
Replies

Cisco PAM Badge Designer Barcode

dcosta963
Beginner
Beginner

We have recently installed Cisco Physical Access Manager V1.2.0. We are using

the included Badge Designer from Glips Graffiti Editor v1.4. Has anyone had any

luck adding a 3 of 9 barcode to the badge design?

Thanks,

Devin

1 Accepted Solution

Accepted Solutions

Michael Brown
Cisco Employee
Cisco Employee

Yes, I have attached a document showing the steps to use a custom font with the Badge Designer.  In the doc, it shows usind the 3of9 barcode font as an example.

Hope this helps,

Mike

View solution in original post

5 Replies 5

Michael Brown
Cisco Employee
Cisco Employee

Yes, I have attached a document showing the steps to use a custom font with the Badge Designer.  In the doc, it shows usind the 3of9 barcode font as an example.

Hope this helps,

Mike

Michael,

     Thank you so much for your reply this is just what we were looking for...

Mike,

That is super!!  Thanks so much for your help with this issue. I have done quite a bit of work on UC with phone integration to CPAM.  Please feel free to reach out to me at anytime with questions on this topic or others.

Best Regards,

Mark Bailey

Mike,

Just finished testing.  Worked like charm.  You are the man!

Yes, Mike has always been 'the man' when it comes to CPAM.

Thanks Mike!

Jim

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: