AAA tacacs appliance 4.1 issue

[TECH SUPPORT]

Hi,

I have a issue here on two of my new switches when i telnet i get username and password once logged in then i go to enable mode i again get a username and password prompt this time the password i have to give is enable password.

This is not a issue on other switches on the network pointing to the same server.I have a standard configuration for aaa on the network.

the switches are running 12.2(33)sxh3a

[TECH SUPPORT]

This is due to a bug in ACS 4.1

The workaround is to update the ACS.

[Premdeep Banga]

Are you sure its a defect on ACS and not on the device IOS ?

CSCsu21040 : Enable authentication prompts for username/password instead of just pass

Version : 12.2(33)SXH03

Integrated in : 12.2(33.03.12)SXH, 12.2(33)SXH04

Regards,

Prem

[TECH SUPPORT]

My mistake it is the device ios that has the bug and not the ACS.

I think i was in a rush so made a mistake here.

Thanks Prem well spotted.