cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3399
Views
0
Helpful
1
Replies

AAA TACACS with Brocade Switches

rkallas
Level 1
Level 1

We are testing authentication on Brocade switches with our AAA TACACS+ server.  It seems that after authenicating to enable mode, you can type "exit" and be dropped back to level 7 mode.  From this point you can type "enable" and authenticate to the switch using the local "enable" password, not from TACACS.  Has anyone run across this and is there a way to correct it?  Is there something that needs to be configured in TACACS on the server to recognise the Brocade switch and make this work?

Ray

1 Reply 1

Amjad Abdullah
VIP Alumni
VIP Alumni

Hi Ray,

What ACS version you are using?

On a cisco switch the following command is used:

switch(config)# aaa authentication enable default tacacs+ enable

The above command is used to set the TACACS+ as the default check for the enable password. If TACACS+ is not available it will fall back to the local enable password.

You need to look into such option in the Brocade switch.

HTH

Amjad

Rating useful replies is more useful than saying "Thank you"

Rating useful replies is more useful than saying "Thank you"
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: