06-04-2012 10:10 PM - edited 03-10-2019 07:09 PM
We have number of GPRS terminals, they work in our private APN. Can we assign static or dynamic IPs to them?
Terminals work with IP, not with PPP. We have direct connect with ISP via serial interface. ISP forwards all Radius traffic to our ACS appliance.
06-05-2012 10:17 PM
You may assign a static ip address. You may try this:
06-06-2012 12:16 AM
Thanx for reply.
I've already tried it, but it does not work. I see in ACS RADIUS Authentication Detail than appliance sent this attribute but terminal don't get it. Strange, but with ACS 3 we didn't have problems assigning static or dynamic IPs to these terminals.
06-06-2012 06:32 AM
What do you mean by terminals? Could you please elborate it?
Also, make sure you've radius accounting enabled on the network access device.
Regards,
Jatin
06-20-2012 01:12 AM
Sorry for late response.
These are POS terminals, and nobody here knows how they work.
Your answer was almost right except name of attribute: giving a name Framed-IP-Address works fine.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: