we are trying to
set up Cisco Secure ACS (5.0) which will automatically allocate unknown
users to a Guest Vlan. 802.1X is configured on the switches but our
lack of undersatnding of the ACS prevents us completing this task. I
am aware that we need to configure radius even though we want Microsoft
AD to do the authentication but we do not know the correct procedure -
any assistance would be appreciated
Hi,
Check out the below link on 802.1x configurtaion in switches along with ACS configuration,hope that help !!
http://www.cisco.com/en/US/tech/tk389/tk814/technologies_configuration_example09186a00808abf2d.shtml -- 802.1x switch and ACS configuration
http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_installation_and_configuration_guide_chapter09186a0080193aa0.html
If helpful do rate the post
Ganesh.H
