cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
507
Views
0
Helpful
5
Replies
Highlighted

AnyConnect Posture Internal System Error message

Hello community,

I've got to configure ISE posture with AnyConnect & ASA for remote access VPN and I get the following error message right when system scan tries to contact ISE server for posture checks.

 

VPN tunnel ok,

DNS resolution ok,

compliance module communicates to policy server,

client provisioning ok.

 

anyconnect-internalsystemerror.png

 

Wondering, if anyone ever stumbled upon this error and maybe has a tip for what might causing it. I'm unable to find anything on the internet...

 

-Setup-

ISE v2.4

ASA v9.6.4

Anyconnect v4.7.04056

ISEComppliance module v4.3.723.4353

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: AnyConnect Posture Internal System Error message

if you can readily reproduce this then open TAC case. its generic and will need the logs looked at. Also this isn't an anyconnect forum
5 REPLIES 5
Cisco Employee

Re: AnyConnect Posture Internal System Error message

if you can readily reproduce this then open TAC case. its generic and will need the logs looked at. Also this isn't an anyconnect forum

Re: AnyConnect Posture Internal System Error message

Thanks, I've already done this and solution found! I thought I could start any tech topic (anyconnect included)....

Cisco Employee

Re: AnyConnect Posture Internal System Error message

You’re going to get the better information under the correct community. This is not the AnyConnect community. Not everyone looks at all communities
Beginner

Re: AnyConnect Posture Internal System Error message

What was your solution? 

Re: AnyConnect Posture Internal System Error message

It wasn't AnyConnect's fault. The error message came up from ISE server and soon I rebooted the ISE server everything came up normal, no error after that.